In daily work, it is often necessary to copy documents, and the paper documents that are copied out are easier to see than on the display, and can also protect the vision from falling. In the office, the copiers are used more often. Sometimes, after copying for a while, the effect of copying the documents is found, and some places are unclear. This indicates that the toner of the toner machine of the copier is not enough, and the toner cartridge needs to be replaced. So, how does the copier replace the toner cartridge? Guangtian Copiers Powder Box Manufacturers Xiaobian is here to introduce you to the common copiers to replace the toner cartridges and methods.

    First, turn off the power of the copier and take out the toner cartridge. Then use a pair of pliers to clamp the metal pin on one side and pull it out carefully (or directly insert the pin into the cartridge and then remove it). Under normal circumstances, we can find out at this time. The toner cartridge can be divided into two parts, the magnetic powder is the powder supply part, and the photosensitive selenium is the waste powder collection part.

    First look at the powder supply part, first screw the screw on the gearless side of the magnetic roller, open the plastic cover, and then clean the toner in the toner cartridge and the magnetic roller with a soft brush. Then re-install the magnetic roller and press it hard to prevent the magnetic roller from coming off the original position. At this time, you can load the toner. Shake the toner and slowly pour it into the powder supply bin. After the good parts are fixed, fix the magnetic roller. Afterwards, gently rotate the gear at one end of the magnetic roller to help the carbon. Evenly attached to the powder.

    The new toner cartridge generally has an ink-proof anti-exposure seal. Do not tear it off before installation to prevent exposure. After installation, it can be removed after checking. In this way, the powder supply part and the collection part are respectively fixed, and then the two parts are installed and restored according to the situation when disassembled, and the fixed bayonet is inserted, and the entire replacement work is declared completed.

    Then, take out the new toner cartridge of the seal, push the two hands to the copying machine, cover the toner cartridge door, and turn on the power of the copier. At this time, the copying machine will self-test for a while. When the photocopier's light is no longer flashing, the page can be tested. Look at the copy effect. If you find the copied document, some places are clear, and some of them are not displayed, you can take out the toner cartridge, hold the two ends of the toner cartridge with both hands, and gently shake the toner cartridge several times, so that the toner in the toner cartridge can be evenly distributed. Then put it in the copier.